QTI SA410m Network-On-Chip interconnect driver binding
-----------------------------------------------------------

Required properties :
- compatible : shall contain only one of the following:
			"qcom,sa410m-bimc",
			"qcom,sa410m-sys_noc",
			"qcom,sa410m-config_noc",
			"qcom,sa410m-clk_virt",
- #interconnect-cells : should contain 1

reg : specifies the physical base address and size of registers
clocks : list of phandles and specifiers to all interconnect bus clocks
clock-names : clock names should include both "bus" and "bus_a"

The following are optional properties:

qcom,util-factor : Parameter that represents the DDR utilization factor
		to be used in aggregation scheme. It is represented as
		actual util-factor * 100.

Examples:

soc {
	...
	system_noc: interconnect@1880000 {
		reg = <0x1880000 0x5e200>;
		compatible = "qcom,sa410m-sys_noc";
		qcom,util-factor = <142>;
		#interconnect-cells = <1>;
		clock-names = "bus", "bus_a";
		clocks = <&rpmcc RPM_SMD_SNOC_CLK>,
			<&rpmcc RPM_SMD_SNOC_A_CLK>;
	};

	config_noc: interconnect@1900000 {
		reg = <0x1900000 0xa400>;
		compatible = "qcom,sa410m-config_noc";
		#interconnect-cells = <1>;
		clock-names = "bus", "bus_a";
		clocks = <&rpmcc RPM_SMD_CNOC_CLK>,
			<&rpmcc RPM_SMD_CNOC_A_CLK>;
	};
};