/* Copyright (c) 2021, The Linux Foundation. All rights reserved.
 *
 * This program is free software; you can redistribute it and/or modify
 * it under the terms of the GNU General Public License version 2 and
 * only version 2 as published by the Free Software Foundation.
 *
 * This program is distributed in the hope that it will be useful,
 * but WITHOUT ANY WARRANTY; without even the implied warranty of
 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
 * GNU General Public License for more details.
 */

/* This file is used for 8550 device which use nxp nfc chipst */

&qupv3_se0_i2c {
        status = "ok";
        qcom,clk-freq-out = <1000000>;
        #address-cells = <1>;
        #size-cells = <0>;
        nq@28 {
                compatible = "qcom,sn-nci";
                reg = <0x28>;
                qcom,sn-irq = <&tlmm 55 0x00>;
                qcom,sn-ven = <&tlmm 30 0x00>;
                qcom,sn-clkreq = <&tlmm 31 0x00>;
                interrupt-parent = <&tlmm>;
                interrupts = <55 0>;
                interrupt-names = "nfc_irq";
                pinctrl-names = "nfc_active", "nfc_suspend";
                pinctrl-0 = <&nfc_int_active &nfc_enable_active>;
                pinctrl-1 = <&nfc_int_suspend &nfc_enable_suspend>;
        };
};

&tlmm {
        nfc_int_active: nfc_int_active {
                /* active state */
                mux {
                     /* NFC Read Interrupt */
                     pins = "gpio55";
                     function = "gpio";
                };

                config {
                     pins = "gpio55";
                     drive-strength = <2>; /* 2 MA */
                     bias-pull-down;
                };
        };

        nfc_int_suspend: nfc_int_suspend {
                /* sleep state */
                mux {
                     /* NFC Read Interrupt */
                     pins = "gpio55";
                     function = "gpio";
                };

                config {
                     pins = "gpio55";
                     drive-strength = <2>; /* 2 MA */
                     bias-pull-down;
                };
        };

        nfc_enable_active: nfc_enable_active {
                mux {
                     /* Enable, Firmware and Clock request gpios */
                     pins = "gpio30", "gpio31";
                     function = "gpio";
                };

                config {
                     pins = "gpio30", "gpio31";
                     drive-strength = <2>; /* 2 MA */
                     bias-disable;
                };
        };

        nfc_enable_suspend: nfc_enable_suspend {
                mux {
                     pins = "gpio30", "gpio31";
                     function = "gpio";
                };

                config {
                     pins = "gpio30", "gpio31";
                     drive-strength = <2>; /* 2 MA */
                     bias-disable;
                };
        };
};