Merge "dt-bindings: devfreq: Add DT bindings for bimc bwmon driver"

bindings/devfreq/bimc-bwmon.txt

@@ -0,0 +1,25 @@
+MSM BIMC bandwidth monitor device
+
+bimc-bwmon is a device that represents the MSM BIMC bandwidth monitors that
+can be used to measure the bandwidth of read/write traffic from the BIMC
+master ports. For example, the CPU subsystem sits on one BIMC master port.
+
+Required properties:
+- compatible:		Must be "qcom,bimc-bwmon"
+- reg:			Pairs of physical base addresses and region sizes of
+			memory mapped registers.
+- reg-names:		Names of the bases for the above registers. Expected
+			bases are: "base", "global_base"
+- interrupts:		Lists the threshold IRQ.
+- qcom,mport:		The hardware master port that this device can monitor
+- qcom,target-dev:	The DT device that corresponds to this master port
+
+Example:
+	qcom,cpu-bwmon {
+		compatible = "qcom,bimc-bwmon";
+		reg = <0xfc388000 0x300>, <0xfc381000 0x200>;
+		reg-names = "base", "global_base";
+		interrupts = <0 183 1>;
+		qcom,mport = <0>;
+		qcom,target-dev = <&cpubw>;
+	};

bindings/devfreq/devfreq_icc.txt

@@ -0,0 +1,40 @@
+MSM devfreq icc device
+
+devfreq icc is a device that represents a MSM device's BW requirements from its
+master port(s) to a different device's slave port(s) in a MSM SoC. This
+device is typically used to vote for BW requirements from a device's (Eg:
+CPU, GPU) master port(s) to the slave (Eg: DDR) port(s).
+
+Required properties:
+- compatible:		Must be "qcom,devfreq-icc"
+- interconnects:	Pairs of phandles and interconnect provider specificers
+			to denote the edge source and destination ports of the
+			desired interconnect path.
+- qcom,bw-tbl:		A list of meaningful instantaneous bandwidth values
+			(in MB/s) that can be requested from the device
+			master port to the slave port. The list of values
+			depend on the supported bus/slave frequencies and the
+			bus width.
+
+Optional properties:
+- qcom,active-only:	Indicates that the bandwidth votes need to be
+			enforced only when the CPU subsystem is active.
+- governor:		Initial governor to use for the device.
+			Default: "performance"
+
+Example:
+
+	qcom,cpubw {
+		compatible = "qcom,devfreq-icc";
+		interconnects = <&mc_virt MASTER_LLCC &mc_virt SLAVE_EBI1>;
+		qcom,active-only;
+		qcom,bw-tbl =
+			<  572 /*  75 MHz */ >,
+			< 1144 /* 150 MHz */ >,
+			< 1525 /* 200 MHz */ >,
+			< 2342 /* 307 MHz */ >,
+			< 3509 /* 460 MHz */ >,
+			< 4684 /* 614 MHz */ >,
+			< 6103 /* 800 MHz */ >,
+			< 7102 /* 931 MHz */ >;
+	};