badpage: vm_normal_page use print_bad_pte

print_bad_pte() is so far being called only when zap_pte_range() finds
negative page_mapcount, or there's a fault on a pte_file where it does not
belong.  That's weak coverage when we suspect pagetable corruption.

Originally, it was called when vm_normal_page() found an invalid pfn: but
pfn_valid is expensive on some architectures and configurations, so 2.6.24
put that under CONFIG_DEBUG_VM (which doesn't help in the field), then
2.6.26 replaced it by a VM_BUG_ON (likewise).

Reinstate the print_bad_pte() in vm_normal_page(), but use a cheaper test
than pfn_valid(): memmap_init_zone() (used in bootup and hotplug) keep a
__read_mostly note of the highest_memmap_pfn, vm_normal_page() then check
pfn against that.  We could call this pfn_plausible() or pfn_sane(), but I
doubt we'll need it elsewhere: of course it's not reliable, but gives much
stronger pagetable validation on many boxes.

Also use print_bad_pte() when the pte_special bit is found outside a
VM_PFNMAP or VM_MIXEDMAP area, instead of VM_BUG_ON.

Signed-off-by: Hugh Dickins <[email protected]>
Cc: Nick Piggin <[email protected]>
Cc: Christoph Lameter <[email protected]>
Cc: Mel Gorman <[email protected]>
Cc: Rik van Riel <[email protected]>
Signed-off-by: Andrew Morton <[email protected]>
Signed-off-by: Linus Torvalds <[email protected]>

mm/internal.h

@@ -49,6 +49,7 @@ extern void putback_lru_page(struct page *page);
 /*
  * in mm/page_alloc.c
  */
+extern unsigned long highest_memmap_pfn;
 extern void __free_pages_bootmem(struct page *page, unsigned int order);
 
 /*