usb: core: handle hub C_PORT_OVER_CURRENT condition

Based on USB2.0 Spec Section 11.12.5,

  "If a hub has per-port power switching and per-port current limiting,
  an over-current on one port may still cause the power on another port
  to fall below specific minimums. In this case, the affected port is
  placed in the Power-Off state and C_PORT_OVER_CURRENT is set for the
  port, but PORT_OVER_CURRENT is not set."

so let's check C_PORT_OVER_CURRENT too for over current condition.

Fixes: 08d1dec6f4 ("usb:hub set hub->change_bits when over-current happens")
Cc: <[email protected]>
Tested-by: Alessandro Antenucci <[email protected]>
Signed-off-by: Bin Liu <[email protected]>
Acked-by: Alan Stern <[email protected]>
Signed-off-by: Greg Kroah-Hartman <[email protected]>
This commit is contained in:
Bin Liu 2018-07-19 14:39:37 -05:00 • committed by Greg Kroah-Hartman
commit 249a32b7ee

View file

@ -1142,10 +1142,14 @@ static void hub_activate(struct usb_hub *hub, enum hub_activation_type type)
if (!udev || udev->state == USB_STATE_NOTATTACHED) {
/* Tell hub_wq to disconnect the device or
* check for a new connection
* check for a new connection or over current condition.
* Based on USB2.0 Spec Section 11.12.5,
* C_PORT_OVER_CURRENT could be set while
* PORT_OVER_CURRENT is not. So check for any of them.
*/
if (udev || (portstatus & USB_PORT_STAT_CONNECTION) ||
(portstatus & USB_PORT_STAT_OVERCURRENT))
(portstatus & USB_PORT_STAT_OVERCURRENT) ||
(portchange & USB_PORT_STAT_C_OVERCURRENT))
set_bit(port1, hub->change_bits);
} else if (portstatus & USB_PORT_STAT_ENABLE) {