block: Inline blk_integrity in struct gendisk

Up until now the_integrity profile has been dynamically allocated and
attached to struct gendisk after the disk has been made active.

This causes problems because NVMe devices need to register the profile
prior to the partition table being read due to a mandatory metadata
buffer requirement. In addition, DM goes through hoops to deal with
preallocating, but not initializing integrity profiles.

Since the integrity profile is small (4 bytes + a pointer), Christoph
suggested moving it to struct gendisk proper. This requires several
changes:

 - Moving the blk_integrity definition to genhd.h.

 - Inlining blk_integrity in struct gendisk.

 - Removing the dynamic allocation code.

 - Adding helper functions which allow gendisk to set up and tear down
   the integrity sysfs dir when a disk is added/deleted.

 - Adding a blk_integrity_revalidate() callback for updating the stable
   pages bdi setting.

 - The calls that depend on whether a device has an integrity profile or
   not now key off of the bi->profile pointer.

 - Simplifying the integrity support routines in DM (Mike Snitzer).

Signed-off-by: Martin K. Petersen <[email protected]>
Reported-by: Christoph Hellwig <[email protected]>
Reviewed-by: Sagi Grimberg <[email protected]>
Signed-off-by: Mike Snitzer <[email protected]>
Cc: Dan Williams <[email protected]>
Signed-off-by: Dan Williams <[email protected]>
Signed-off-by: Jens Axboe <[email protected]>

block/partition-generic.c

@@ -428,6 +428,7 @@ rescan:
 
 	if (disk->fops->revalidate_disk)
 		disk->fops->revalidate_disk(disk);
+	blk_integrity_revalidate(disk);
 	check_disk_size_change(disk, bdev);
 	bdev->bd_invalidated = 0;
 	if (!get_capacity(disk) || !(state = check_partition(disk, bdev)))