hwmon: Add Asus ATK0110 support

Asus boards have an ACPI interface for interacting with the hwmon (fan,
temperatures, voltages) subsystem; this driver exposes the relevant
information via the standard sysfs interface.

There are two different ACPI interfaces:
- an old one (based on RVLT/RFAN/RTMP)
- a new one (GGRP/GITM)
Both may be present but there a few cases (my board, sigh) where the
new interface is just an empty stub; the driver defaults to the old one
when both are present.
The old interface has received a considerable testing, but I'm still
awaiting confirmation from my tester that the new one is working as
expected (hence the debug code is still enabled).

Currently all the attributes are read-only, though a (partial) control
should be possible with a bit more work.

Signed-off-by: Luca Tettamanti <[email protected]>
Signed-off-by: Hans de Goede <[email protected]>
Signed-off-by: Jean Delvare <[email protected]>

drivers/hwmon/Kconfig

@@ -248,6 +248,18 @@ config SENSORS_ASB100
 	  This driver can also be built as a module.  If so, the module
 	  will be called asb100.
 
+config SENSORS_ATK0110
+	tristate "ASUS ATK0110 ACPI hwmon"
+	depends on X86 && ACPI && EXPERIMENTAL
+	help
+	  If you say yes here you get support for the ACPI hardware
+	  monitoring interface found in many ASUS motherboards. This
+	  driver will provide readings of fans, voltages and temperatures
+	  through the system firmware.
+
+	  This driver can also be built as a module. If so, the module
+	  will be called asus_atk0110.
+
 config SENSORS_ATXP1
 	tristate "Attansic ATXP1 VID controller"
 	depends on I2C && EXPERIMENTAL

drivers/hwmon/Makefile

@@ -32,6 +32,7 @@ obj-$(CONFIG_SENSORS_ADT7475)	+= adt7475.o
 
 obj-$(CONFIG_SENSORS_APPLESMC)	+= applesmc.o
 obj-$(CONFIG_SENSORS_AMS)	+= ams/
+obj-$(CONFIG_SENSORS_ATK0110)	+= asus_atk0110.o
 obj-$(CONFIG_SENSORS_ATXP1)	+= atxp1.o
 obj-$(CONFIG_SENSORS_CORETEMP)	+= coretemp.o
 obj-$(CONFIG_SENSORS_DME1737)	+= dme1737.o