backlight: cr_bllcd: use pr_err()/pr_info() instead of printk()

Use pr_err()/pr_info() instead of printk() to allow dynamic debugging.
The pr_fmt prefix for pr_ macros is used.  Also fix checkpatch warnings as
below:

WARNING: printk() should include KERN_ facility level
WARNING: Prefer pr_err(... to printk(KERN_ERR, ...

[[email protected]: use KBUILD_MODNAME, per Joe]
Signed-off-by: Jingoo Han <[email protected]>
Cc: Richard Purdie <[email protected]>
Cc: Joe Perches <[email protected]>
Signed-off-by: Andrew Morton <[email protected]>
Signed-off-by: Linus Torvalds <[email protected]>
This commit is contained in:
Jingoo Han 2012-05-29 15:07:17 -07:00 • committed by Linus Torvalds
commit 31e6432b32

View file

@ -27,6 +27,8 @@
* Alan Hourihane <alanh-at-tungstengraphics-dot-com>
*/
#define pr_fmt(fmt) KBUILD_MODNAME ": " fmt
#include <linux/module.h>
#include <linux/kernel.h>
#include <linux/init.h>
@ -180,14 +182,13 @@ static int cr_backlight_probe(struct platform_device *pdev)
lpc_dev = pci_get_device(PCI_VENDOR_ID_INTEL,
CRVML_DEVICE_LPC, NULL);
if (!lpc_dev) {
printk("INTEL CARILLO RANCH LPC not found.\n");
pr_err("INTEL CARILLO RANCH LPC not found.\n");
return -ENODEV;
}
pci_read_config_byte(lpc_dev, CRVML_REG_GPIOEN, &dev_en);
if (!(dev_en & CRVML_GPIOEN_BIT)) {
printk(KERN_ERR
"Carillo Ranch GPIO device was not enabled.\n");
pr_err("Carillo Ranch GPIO device was not enabled.\n");
pci_dev_put(lpc_dev);
return -ENODEV;
}
@ -270,7 +271,7 @@ static int __init cr_backlight_init(void)
return PTR_ERR(crp);
}
printk("Carillo Ranch Backlight Driver Initialized.\n");
pr_info("Carillo Ranch Backlight Driver Initialized.\n");
return 0;
}