[PATCH] Typo fixes

Fix a lot of typos.  Eyeballed by jmc@ in OpenBSD.

Signed-off-by: Alexey Dobriyan <[email protected]>
Signed-off-by: Andrew Morton <[email protected]>
Signed-off-by: Linus Torvalds <[email protected]>

drivers/net/irda/nsc-ircc.c

@@ -812,7 +812,7 @@ static int nsc_ircc_init_39x(nsc_chip_t *chip, chipio_t *info)
 	int cfg_base = info->cfg_base;
 	int enabled;
 
-	/* User is shure about his config... accept it. */
+	/* User is sure about his config... accept it. */
 	IRDA_DEBUG(2, "%s(): nsc_ircc_init_39x (user settings): "
 		   "io=0x%04x, irq=%d, dma=%d\n", 
 		   __FUNCTION__, info->fir_base, info->irq, info->dma);

drivers/net/sis900.c

@@ -2283,7 +2283,7 @@ static void set_rx_mode(struct net_device *net_dev)
 	int i, table_entries;
 	u32 rx_mode;
 
-	/* 635 Hash Table entires = 256(2^16) */
+	/* 635 Hash Table entries = 256(2^16) */
 	if((sis_priv->chipset_rev >= SIS635A_900_REV) ||
 			(sis_priv->chipset_rev == SIS900B_900_REV))
 		table_entries = 16;

drivers/net/tulip/de4x5.c

@@ -513,7 +513,7 @@ struct mii_phy {
     u_char  *rst;           /* Start of reset sequence in SROM           */
     u_int mc;               /* Media Capabilities                        */
     u_int ana;              /* NWay Advertisement                        */
-    u_int fdx;              /* Full DupleX capabilites for each media    */
+    u_int fdx;              /* Full DupleX capabilities for each media   */
     u_int ttm;              /* Transmit Threshold Mode for each media    */
     u_int mci;              /* 21142 MII Connector Interrupt info        */
 };

drivers/net/tulip/pnic2.c

@@ -199,7 +199,7 @@ void pnic2_lnk_change(struct net_device *dev, int csr5)
 	               /* negotiation ended successfully */
 
 	               /* get the link partners reply and mask out all but
-                        * bits 24-21 which show the partners capabilites
+                        * bits 24-21 which show the partners capabilities
                         * and match those to what we advertised
                         *
                         * then begin to interpret the results of the negotiation.

drivers/net/typhoon.c

@@ -208,7 +208,7 @@ static const struct typhoon_card_info typhoon_card_info[] __devinitdata = {
 };
 
 /* Notes on the new subsystem numbering scheme:
- * bits 0-1 indicate crypto capabilites: (0) variable, (1) DES, or (2) 3DES
+ * bits 0-1 indicate crypto capabilities: (0) variable, (1) DES, or (2) 3DES
  * bit 4 indicates if this card has secured firmware (we don't support it)
  * bit 8 indicates if this is a (0) copper or (1) fiber card
  * bits 12-16 indicate card type: (0) client and (1) server
@@ -788,7 +788,7 @@ typhoon_start_tx(struct sk_buff *skb, struct net_device *dev)
 	/* we have two rings to choose from, but we only use txLo for now
 	 * If we start using the Hi ring as well, we'll need to update
 	 * typhoon_stop_runtime(), typhoon_interrupt(), typhoon_num_free_tx(),
-	 * and TXHI_ENTIRES to match, as well as update the TSO code below
+	 * and TXHI_ENTRIES to match, as well as update the TSO code below
 	 * to get the right DMA address
 	 */
 	txRing = &tp->txLoRing;

drivers/net/wireless/orinoco.c

@@ -3858,7 +3858,7 @@ static int orinoco_ioctl_setscan(struct net_device *dev,
 	unsigned long flags;
 
 	/* Note : you may have realised that, as this is a SET operation,
-	 * this is priviledged and therefore a normal user can't
+	 * this is privileged and therefore a normal user can't
 	 * perform scanning.
 	 * This is not an error, while the device perform scanning,
 	 * traffic doesn't flow, so it's a perfect DoS...

drivers/net/wireless/prism54/isl_ioctl.c

@@ -747,7 +747,7 @@ prism54_get_essid(struct net_device *ndev, struct iw_request_info *info,
 
 	if (essid->length) {
 		dwrq->flags = 1;	/* set ESSID to ON for Wireless Extensions */
-		/* if it is to big, trunk it */
+		/* if it is too big, trunk it */
 		dwrq->length = min((u8)IW_ESSID_MAX_SIZE, essid->length);
 	} else {
 		dwrq->flags = 0;