ACPI / ACPICA: Fix low-level GPE manipulation code

ACPICA uses acpi_ev_enable_gpe() for enabling GPEs at the low level,
which is incorrect, because this function only enables the GPE if the
corresponding bit in its enable register's enable_for_run mask is set.
This causes acpi_set_gpe() to work incorrectly if used for enabling
GPEs that were not previously enabled with acpi_enable_gpe().  As a
result, among other things, wakeup-only GPEs are never enabled by
acpi_enable_wakeup_device(), so the devices that use them are unable
to wake up the system.

To fix this issue remove acpi_ev_enable_gpe() and its counterpart
acpi_ev_disable_gpe() and replace acpi_hw_low_disable_gpe() with
acpi_hw_low_set_gpe() that will be used instead to manipulate GPE
enable bits at the low level.  Make the users of acpi_ev_enable_gpe()
and acpi_ev_disable_gpe() call acpi_hw_low_set_gpe() instead and
make sure that GPE enable masks are only updated by acpi_enable_gpe()
and acpi_disable_gpe() when GPE reference counters change from 0
to 1 and from 1 to 0, respectively.

Signed-off-by: Rafael J. Wysocki <[email protected]>
Signed-off-by: Len Brown <[email protected]>

include/acpi/actypes.h

@@ -663,7 +663,7 @@ typedef u32 acpi_event_status;
 #define ACPI_GPE_MAX                    0xFF
 #define ACPI_NUM_GPE                    256
 
-/* Actions for acpi_set_gpe */
+/* Actions for acpi_set_gpe and acpi_hw_low_set_gpe */
 
 #define ACPI_GPE_ENABLE                 0
 #define ACPI_GPE_DISABLE                1