Increase QMI and MHI default timeouts for emulation builds. Also
set timeout for MHI power on as multiple default timeout value
instead of a fixed number so that it can be changed at runtime
for debug purpose.
Change-Id: I483a458f54083644f9acd2a484243016901c4776
Signed-off-by: Yue Ma <yuem@codeaurora.org>
This reverts commit b9b4ade986.
Older ver of SNPS core needs viewport registers as it does not
have separate iATU region. Hence keep the viewport support.
Change-Id: Ic863eb3332c54df433726064591a01dc50d29565
Signed-off-by: Hemant Kumar <hemantk@codeaurora.org>
Enable arm smmu driver on SDMSTEPPE_AUTO target
so that clients can use.
Change-Id: I9136126de2e08e19daca897476aa6e6c943c2b8b
Signed-off-by: Shreyas K K <shrekk@codeaurora.org>
If higher 4 bits of chip ID (device major version) is 1, read board
data file name as bdwlang.e<board ID>. The assumption is board ID
will be always less than 0xFF. If board ID (0xFF) is invalid in OTP
then read it as bdwlang.elf for such case. Also only use lower 4 bits
of device major version as the version number to load firmware file
because of above new requirement.
Change-Id: I4dce528a9c389a660b19dabe4ee44e655a23570b
Signed-off-by: Yue Ma <yuem@codeaurora.org>
The weak symbols are no longer needed as the WALT code is
moved from techpack to kernel.
Change-Id: I2918ac475d264482b039ee8b65357657c427eb28
Signed-off-by: Pavankumar Kondeti <pkondeti@codeaurora.org>
This change is for general scheduler improvemnts.
Change-Id: If28d00691bc42b62cc4fc96a49d601c7ac5e3e34
Signed-off-by: Pavankumar Kondeti <pkondeti@codeaurora.org>
Currently composite driver is calling get_status for the function
drivers which supports remote wakeup capability. Instead of this
have another judgement to check whether the device is advertising
remote wakeup capability.
Change-Id: I6e907b2a05ea64e04aa50ee90c4eb53b86b027d4
Signed-off-by: Pratham Pratap <prathampratap@codeaurora.org>
enable qcom_scm and fastcvpd for vidc driver.
Change-Id: Idb17a079e1472e1d2a853d2ea68da6933768d7e1
Signed-off-by: Laisheng Hu <laisheng@codeaurora.org>
Consider a case where ep0 is not in setup stage and composition
switch happens. Currently DWC3_DEPCMD_ENDTRANSFER command is not
issued on ep0 which means that the transfers are not flushed out
and driver clears the run/stop bit hence stopping the controller.
Now as soon as driver sets the run/stop bit controller tries to
access the trb from the previous session which is already unmapped
resulting in SMMU fault.
Fix this by unconditionally issuing DWC3_DEPCMD_ENDTRANSFER
command on ep0. Although it is not specified in the data book
but if we know for sure that we are anyway going to stop the
controller then we can issue ENDTRANSFER command on ep0.
Change-Id: Ic6ee570acc8926897d3b6042181a501a47438d92
Signed-off-by: Pratham Pratap <prathampratap@codeaurora.org>
