Propagate following changes from 4.19 to 5.4 for I2C and GSI driver.
'commit 22cec88da571 ("i2c: i2c-qcom-geni: Add lock and unlock tre
support in I2C GSI mode")',
'commit 3adda53e090d ("i2c: i2c-qcom-geni: Enable shared flag in GSI
mode only")',
'commit 6f84a3f8ca30 ("i2c: i2c-qcom-geni: Enhance IPC logging debug
infra in I2C")',
'commit d06ac0169fb7 ("i2c: i2c-qcom-geni: Correct the IEOB/IEOT
sequence for I2C GSI tres")'.
Change-Id: I8ab0b4d580b16041b751f0be3de717d32238a374
Signed-off-by: Vipin Deep Kaur <vkaur@codeaurora.org>
Currently, ucsi_qti_notify() is checking the received data from
charger firmware (PPM) to see if there is any connector status
response with partner accessory information (e.g. analog audio).
It does this based on setting a flag (cmd_requested_flags) when
UCSI_GET_CONNECTOR_STATUS command is sent from UCSI framework to
PPM so that the response for that command can be read and clients
registered for getting notification on partner accessory can get
notified. However, in a certain scenario, multiple response for
different commands can be received from PPM. See a possible
example below.
1. UCSI framework sends UCSI_GET_CONNECTOR_STATUS command
2. ucsi_glink driver sets cmd_requested_flags, waits for response
3. UCSI framework sends UCSI_GET_CURRENT_CAM command
4. ucsi_glink driver gets a response for UCSI_GET_CONNECTOR_STATUS
and schedules notify_work since ucsi_qti_notify() is called
with cmd_requested_flags set.
5. ucsi_glink driver gets a response for UCSI_GET_CURRENT_CAM and
this can end up reading "flags" because cmd_requested_flags is
not cleared yet. However, this causes a buffer overflow because
ucsi_qti_read() passes "val" pointer passed from UCSI framework
which is of 1 byte length and ucsi_qti_notify() ends up reading
"flags" which is at an offset 2 of length 9 bytes.
6. ucsi_qti_notify_work() clears cmd_requested_flags.
Fix this by checking the message length in ucsi_qti_notify()
to ensure that status->flags is read only when a response is
received for UCSI_GET_CONNECTOR_STATUS. Also, relocate the
clearing of "cmd_requested_flags" flag.
CRs-Fixed: 2678391
Change-Id: Iac1d5c58e1ed2fd0f3bc153da23cddf0700cc097
Signed-off-by: Subbaraman Narayanamurthy <subbaram@codeaurora.org>
Register driver work handler will only power up device, resume PCIe
link and start MHI to download firmware. It may only block there
for a timeout, so there is no need to post it as killable event.
Change-Id: Ib82050358dc8df4a8163ecb43702aa86ed34f23d
Signed-off-by: Yue Ma <yuem@codeaurora.org>
For uniprocessor systems, add a NULL definition of tick_broadcast to
add support for tick broadcast.
Change-Id: I7dc47984cb6b60c9814171888f6adbc480a1e990
Signed-off-by: Mahesh Sivasubramanian <msivasub@codeaurora.org>
