Disable regulator supplies of analog codec during suspend
to reduce power consumption.
CRs-Fixed: 2132296
Change-Id: Ia4b690f01e83e929f8bf4d279454e2ff2e8655a2
Signed-off-by: Rohit kumar <rohitkr@codeaurora.org>
Add support for analog mic TX hybrid mode to allow
audio catpure in high performance at the same time
achieving lower power.
CRs-Fixed: 2136385
Change-Id: I08b90a26d6b6e4761ff17dec84bf58f8d437d908
Signed-off-by: Karthikeyan Mani <kmani@codeaurora.org>
Pop sound happens after start playback on HPH when
ultrasound playback on LO4 is enabled.
This is because CnP is sequence dependent and enabling
design blocks in specified order is causing minimum CnP.
CRs-Fixed: 2100346
Change-Id: If10f9013cc1a2aa61fe9c719d3190f2df0b00950
Signed-off-by: Vatsal Bucha <vbucha@codeaurora.org>
Set bus_down_in_recovery flag as soon as possible when
BUS down notification reaches codec driver. This is to
avoid any unwanted slimbus transaction while BUS is still
not recovered.
Change-Id: I77917975372bf51e6aa881cbfc63c479478db375
Signed-off-by: Banajit Goswami <bgoswami@codeaurora.org>
Reset ASRC after audio playback is completed to clear
the FIFO and avoid any noise being generated.
CRs-Fixed: 2129994
Change-Id: Ie45796e1bd68d5a8bd790490a65520358f26b811
Signed-off-by: Walter Yang <yandongy@codeaurora.org>
This reverts commit 40bc50d768038c04f8c1 ("mfd: wcd9xxx-core:
Synchronize codec down and reset calls from slimbus.").
This is to make sure that the dev_up flag is set right
after device_down is called from Slimbus after ADSP SSR.
This flag helps make sure that all read/write calls over
slimbus are blocked until ADSP and Slimbus are fully up
post-SSR.
Change-Id: I5595a23a0b51f2ca392ddfb5773b057204185b54
Signed-off-by: Banajit Goswami <bgoswami@codeaurora.org>
Fix qos value to 300 micro seconds to prevent core
from going into low power mode when low latency
session is active. Also pin this qos to core 1
& core 2 where audio and glink threads are
running to let other cores to go to low power
modes if possible.
Change-Id: I46d356c384fd8d02a9a3b336a113200171bf25a0
Signed-off-by: Haynes Mathew George <hgeorge@codeaurora.org>
Signed-off-by: Dhananjay Kumar <dhakumar@codeaurora.org>
Signed-off-by: Aniket Kumar Lata <alata@codeaurora.org>
Clean up unused FE DAIs and remove duplicate
routings from dapm routing map for MI2S_RX_VOICE
Mixer.
CRs-Fixed: 2001153
Change-Id: I2c9bd1255331d83b1901915259fe61d287f682fc
Signed-off-by: kunleiz <kunleiz@codeaurora.org>
Excess logs are printed in msm_compr_pointer during ADSP SSR.
This causes failure of some interrupts to occur which
results in SSR failure. Logs can be reduced by applying ratelimit.
CRs-Fixed: 2128011
Change-Id: I0d3d82bf52ea307cdf719f97c4907a2d376580c1
Signed-off-by: Vatsal Bucha <vbucha@codeaurora.org>
Variable 'vm_page_prot' has different types in different
ARM platforms. Using macro "pgprot_val" to handle it to
fix compilation issue for sdxpoorwills targets.
Change-Id: Ic7b8de9860759cc56812e7a3ffb1aaea2b6779f9
Signed-off-by: Xiaoyu Ye <benyxy@codeaurora.org>
Enable compilation of audio drivers for SDXPOORWILLS.
Change-Id: I2a8d949f98ab6fb56111dffdab51d9123a41c3c1
Signed-off-by: Xiaoyu Ye <benyxy@codeaurora.org>
Pop is observed during switch from playback in native mode
to voice call and vice-versa. This is resolved by mclk
reset to non-native mode before hph path powers up.
CRs-Fixed: 2117960
Change-Id: Ic554c3b2af24dac3ae94b5a239559e5d11e98271
Signed-off-by: Vatsal Bucha <vbucha@codeaurora.org>
Add mutex unlock in function audio_effects_shared_ioctl
at appropriate place to prevent use after free.
CRs-Fixed: 2123291
Change-Id: Ie0d321dc8cc20a295d102a44faea7e5710834932
Signed-off-by: Tanya Dixit <tdixit@codeaurora.org>
For MI2S and AUXPCM shutdown, if clock disable is failed,
do not bother to re-increment clock reference. Otherwise,
next time when startup is called, clock enable will not
be called again, so use case will not work.
Change-Id: I5ce4590d2a2030f9d00f1dba9577396f7685a87b
Signed-off-by: Banajit Goswami <bgoswami@codeaurora.org>
Signed-off-by: Xiaoyu Ye <benyxy@codeaurora.org>
Update make files to extend dlkm support for qcs605
Change-Id: Icf736fb66ca12966f4c6cd72bb906eb32899868a
Signed-off-by: Laxminath Kasam <lkasam@codeaurora.org>
lb_mode var is redundant for sdm660_cdc.
Loopback works fine without this var also.
CRs-Fixed: 2101423
Change-Id: I727da02660a0f1d6ee5582fc2f2c0a8f6cd59bc1
Signed-off-by: Vatsal Bucha <vbucha@codeaurora.org>
Pop is observed after start playback on hph.
This is because both compander channels are not enabled
at the same time which differs from ideal sequence.
Amplitude of pop gets reduced after
corresponding change is made.
CRs-Fixed: 2101404
Change-Id: Iba2b8a809fd3b53f0c180ce28ac5668d7635fb24
Signed-off-by: Vatsal Bucha <vbucha@codeaurora.org>
If compander DRE isn't turned on, ensure analog gain mode
is set to manual mode. This also resolves low volume
at one channel.
CRs-Fixed: 2102126
Change-Id: Id29b7055fe4f7fa7b3853c26770df38d10539d8c
Signed-off-by: Vatsal Bucha <vbucha@codeaurora.org>
Kernel panic is observed during SSR. This is because
ADSP does not get sufficient time to bring up LPASS after SSR.
An increase in ADSP Ready timeout resolves the issue.
CRs-Fixed: 2101404
Change-Id: Ia7d1ecde7a713b4d71b2a4ebb1f85a38b8fa28b5
Signed-off-by: Vatsal Bucha <vbucha@codeaurora.org>
Add a new mixer ctl to set WSA boost value for
speaker protection v3. Boost value for different
stages are packed together.
Change-Id: Ie80d7bea4d3af00b74935f8b680e72ee967717f6
Signed-off-by: Xiaojun Sang <xsang@codeaurora.org>
Add new mixer ctls to control max boost state level
for speaker protection V3.
Change-Id: If967de46955f6dc8692986503daea68ce105f642
Signed-off-by: Xiaojun Sang <xsang@codeaurora.org>
Add a new AFE API to send limiter threshold to ADSP.
Change-Id: Ibcd795d7c0edb4f081636c621e51e5a1eaa036b1
Signed-off-by: Xiaojun Sang <xsang@codeaurora.org>
To support speaker protection v3, add sp version and
limiter threshold in spk_prot_cfg struct.
Change-Id: Ia4c89934e00bfa8c0e0c6823f48d56baf6759f14
Signed-off-by: Xiaojun Sang <xsang@codeaurora.org>
Add support for quinary pcm and tdm interfaces in q6audio.
CRs-Fixed: 2133890
Change-Id: I59ca2965f5d38d30bea5a00f34898af5c948ac16
Signed-off-by: Rohit kumar <rohitkr@codeaurora.org>
Update quinary mi2s dai id to 4 and secondary mi2s playback
sd1 dai id to 5. Also update index of mi2s_config_controls
for primary, secondary, tertiary and quaternary mi2s.
CRs-Fixed: 2133890
Change-Id: I00997b79a148cf50b2a3f9acf6e44fe603e5c944
Signed-off-by: Rohit kumar <rohitkr@codeaurora.org>
Update quinary mi2s cpu dai id to 4 for sdm670. This is
required for sending correct afe port id for quin mi2s
and keep all MI2S interfaces in sequence.
CRs-Fixed: 2133890
Change-Id: I0ab35f2d97858f355da577076a5a1e3f438a1bab
Signed-off-by: Rohit kumar <rohitkr@codeaurora.org>
Switch to DLKM for all audio kernel modules.
Change-Id: I6a96023a21f655f873531af9ace81f2b01eb0f58
Signed-off-by: Laxminath Kasam <lkasam@codeaurora.org>
