Keeping "no_console_suspend" causing a frequent wakeups when VM enter
into suspend state. This is because console is implemented on RM
console where RM console interrupts are configured as wakeup capable.
Remove "no_console_suspend" to avoid wakeups. User can control this
feature using below node.
echo Y > /sys/module/printk/parameters/console_suspend.
Change-Id: I1bd5f0832802ff4b350707632d74aa0f7cd3c9d9
Keeping "no_console_suspend" causing a frequent wakeups when VM enter
into suspend state. This is because console is implemented on RM
console where RM console interrupts are configured as wakeup capable.
Remove "no_console_suspend" to avoid wakeups. User can control this
feature using below node.
echo Y > /sys/module/printk/parameters/console_suspend.
Change-Id: Iefd7f78c4155c9fa80e634c5799aa52024804c86
The PDC wakeup value is written to the control TCS. This is now handled
in trusted firmware. Set Control TCS count to zero to disable writing
to control TCS.
Change-Id: If90bea0fadf4decffa2f1ae1c2214cf5b76f5061
The wakeup value will be programmed by the secure firmware. This is
noted as the new E3 state for the RSC component.
Update state id for the AOSS sleep mode to pass new state.
Change-Id: I4c70bfa7f442e28a59d8809d2bd5afb6557de1d8
Add scm and scm pas device tree nodes for Olympic target.
These are required for pil image authentication.
Change-Id: I4fd67c5a6861e83679178cd3fa0b0f221f5142e8
Add trusted touch properties to focaltech node to support
VM(virtual machine) enabled trusted touch on shima platform.
Change-Id: I7fa55db0905ab800e960981c6bd1fb7704f58dd6
Enable shutdown ack smp2p interrupt for adsp/cdsp for Shima, so that
it can handle the ack sent by the subsystem for a shutdown.
Change-Id: Ifbc3ae53941b5eb00ec21cdf367987f3647f7085
With the current jeita-fcc-step thresholds observing multiple
frequent JEITA entry-exit event while charging with higher
charge current for longer time, When the JEITA condition
is hit, the charge-current is reduced significantly until
the battery temperature drops below sw-jeita-hys threshold
which causes the overall charge time to increase. Optimize
Optimize this by adding some intermediate steps between
10.00A and 1.89A. While at it also change the hysteresis
for the same.
Change-Id: I8812dfbad10c6cbb0726077106653b9bc27a576d
