EPD support is configured as a part of config blob. Currently global
reset is invoked after CSID is configured and as a part of that
epd support attributre gets reset. This cause CPHY_EOT_RECEPTION
error from CSID. This change removes reset part of epd supported
attribute to continue with the expected opertion set during
configuration of CSID. Also, set this attribute to zero by default
at probe time to make sure epd is not supported.
CRs-Fixed: 2775508
Change-Id: I0f49f952d2156d92eb0fb1813951a325b63e60b0
Signed-off-by: Jigarkumar Zala <jzala@codeaurora.org>
During first CCI HW initialization, CCI HW global reset has to be called.
Removed is_initialized removed, as it can be controlled through
master_active_slave ref count to verify there is any active slave or not.
CRs-Fixed: 2782553
Change-Id: Id845bfc936b976e160231ed3a0acbc951c32ad7f
Signed-off-by: Anil Kumar Kanakanti <akanakan@codeaurora.org>
Reduced maximum no of requests per context from 20 to 8
in isp driver.
CRs-Fixed: 2720238
Change-Id: If557b190fe94af72cc6fb28f36c3e1f6189218a5
Signed-off-by: Shravya Samala <shravyas@codeaurora.org>
Fix the order of imports for to resolve cam_sync
typedef for kernel CFI.
CRs-Fixed: 2772200
Change-Id: I4e5e642e6b45412904585aaa68c0ef77fedeee2d
Signed-off-by: Karthik Jayakumar <kjayakum@codeaurora.org>
Increase max bl limit for OPE to 24 to support maximum
48 stripes.
CRs-Fixed: 2761455
Change-Id: I961be1344fac0084649df321225e94a50d4e5a98
Signed-off-by: Rishabh Jain <risjai@codeaurora.org>
Remove following unused CCI and CPHY flags.
CRs-Fixed: 2709537
Change-Id: I7a936733da75c71877ae52cfae9ddd358775c305
Signed-off-by: Jigar Agrawal <jigar@codeaurora.org>
This change takes care of a race which we see when we halt master
csid immediately and slave csid halt to follow. In some scenarios
after master csid halt, slave gives violation errors.
With this change we are first changing the mode of slave to master
then issue halt commands to both master and slave.
CRs-Fixed: 2773668
Change-Id: Iab7baa41a69b2e4e0a658c7abac29d2dcb80c289
Signed-off-by: Ayush Kumar <ayushkr@codeaurora.org>
When workqueue is congested, CRM may apply same
request to device which will trigger recovery
due to apply fails. This change prevent CRM
triggering recovery if the time interval of
continuous applying req less than 5ms.
CRs-Fixed: 2775372
Change-Id: I45c2ed76334b1bbf4547bbf21f90cf0a6c169323
Signed-off-by: Depeng Shao <depengs@codeaurora.org>
Drop references to A5 within the debugfs entries so that they
may be reused with other processors.
CRs-Fixed: 2722486
Change-Id: I2680a98dd3d38906e616712da3d6e2835ebb9a85
Signed-off-by: Fernando Pacheco <fpacheco@codeaurora.org>
The A5 references sprinkled throughout the hw manager will no
longer make sesne within the context of two possible processors.
We will instead prefer the more generic "icp" term to reference
the processor in use e.g. icp_dev instead of a5_dev.
Note that some references to A5 remain and will be cleaned up
when LX7 is introduced.
CRs-Fixed: 2722486
Change-Id: I9af73cc2af27a2aed2f4d7baaead89a20442e9ed
Signed-off-by: Fernando Pacheco <fpacheco@codeaurora.org>
The HFI interface registers will have a different base address
on the LX7 processor. We can utilize the newly added HFI ops to
abstract the calculation of the address by kicking that info out
to the device interface. The HFI register definitions have been
tweaked to support offsets based on the calculated addresses.
CRs-Fixed: 2722486
Change-Id: I93b9b2827ec0820eaac6ee2e6a611363b96a3223
Signed-off-by: Fernando Pacheco <fpacheco@codeaurora.org>
If bubble recovery is disabled, IFE driver should continue
to notify that epoch to CRM as opposed to dropping that frame
in IFE. In case of sHDR if bubble recovery is disabled and IFE
does not notify the epoch at which bubble was detected it will lead
to a trigger count mismatch in CRM.
CRs-Fixed: 2768309
Change-Id: I311ce80857a905496c633708a5f4ee2391679037
Signed-off-by: Karthik Anantha Ram <kartanan@codeaurora.org>
CCI register dump is only enable when dump flag is defined. Remove
this flag and add control via debugfs entry. This change helps
debugfs entry to control cci device individually on the fly for
debugging rather than to rebuild.
CRs-Fixed: 2692379
Change-Id: Ic13dc903e861e7c49bf3b375a66b96bfbe5d9c70
Signed-off-by: shiwgupt <shiwgupt@codeaurora.org>
Calculate the total clk of all the ctx
irrespective of the use case for the ctx. Remove
dev_type check to add all the ctx clk while
calculating total clk.
CRs-Fixed: 2754351
Change-Id: I5c1681ac1a88cfec752ff58fd8b1f6ac5d05b28a
Signed-off-by: Tejas Prajapati <tpraja@codeaurora.org>
Userspace sends the hbi count as part of acquire. Use that
value to compute min hbi and progam the same in IPP path cfg.
CRs-Fixed: 2772278
Change-Id: Ia41c435b0fb010a3b841fa11bfcdffc4c4a11006
Signed-off-by: Karthik Anantha Ram <kartanan@codeaurora.org>
In case large memory slot usage scene like MFHDR, MFSR.
increase kernel slot count to avoid out of memory issue.
CRs-Fixed: 2718732
Change-Id: I49dd2d9bdda548d5f95fa49c290364ecb6d40f6e
Signed-off-by: bohahuan <bohahuan@codeaurora.org>
TPG core cfg data is sent by userspace as a blob. Add
support to configure the same at stream on.
CRs-Fixed: 2772256
Change-Id: I94b9e3fd8aaf02e9ea6d1e7fa10de9cbbc43e39d
Signed-off-by: Karthik Anantha Ram <kartanan@codeaurora.org>
Signed-off-by: Mukund Madhusudan Atre <matre@codeaurora.org>
Add initial code drop for SFE HW.
CRs-Fixed: 2733230
Change-Id: I44437bbe05d8c60d219c31cb626a4c9845a469e0
Signed-off-by: Jigarkumar Zala <jzala@codeaurora.org>
cdm client check for loading number of clients is
not correct. It does not take error codes into account.
The variable that holds the value is of incorrect
data type.
CRs-fixed: 2768636
Change-Id: Ie5b752aa6bc7a70fe777c16a70a5bdb2e5a663a4
Signed-off-by: Jigar Agrawal <jigar@codeaurora.org>
