In the existing code, Over Current Protection interrupt is enabled
as part of MBHC insertion event handling.
This is causing audio mute on Stereo Headset randomly.
This OCP through MBHC is no more required as the
Over Current/surge is handled in HW.
Removing the OCP enabling code to fix the issue.
CRs-Fixed: 2622368
Change-Id: Iae8994aa365eb294793190f665407af111b23c82
Signed-off-by: Ramlal Karra <rkarra@codeaurora.org>
Add variable bit rate mode support for aac codec.
Change-Id: Iedd9fe0df2d3a12e3d4e6c2916305399da10873f
Signed-off-by: Manisha Agarwal <maniagar@codeaurora.org>
Add support to disable dynamic port map via device tree
property.
Do not update master clock when dynamic port map
is disabled for a sound wire master.
Change-Id: I9f9344866faa4d1c342787e014102d9182ed56ae
Signed-off-by: Vignesh Kulothungan <vigneshk@codeaurora.org>
After playback on speaker, remove from soundwire group to
properly close the soundwire port configuration.
Change-Id: I278e7510869200bc1236eb45968bc8d986a93a96
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
Signed-off-by: Laxminath Kasam <lkasam@codeaurora.org>
From kernel 5.4, device node properties with
-gpio/-gpios suffix in the name is expected to define
gpio node properities like "#gpio-cells".
Update non-gpio property names to not have -gpio/-gpios
suffix.
Change-Id: I63fc81ce16c4e9705a08a3762aa91c7cacd174b5
Signed-off-by: Vignesh Kulothungan <vigneshk@codeaurora.org>
Add external display dai links to sound card only when
CONFIG_AUDIO_QGKI is enabled.
Change-Id: Ic67def877cddeb08aebcfc00ab4886826905b7c2
Signed-off-by: Vignesh Kulothungan <vigneshk@codeaurora.org>
Compile hdmi_dlkm kernel module only when both
CONFIG_SND_SOC_MSM_HDMI_CODEC_RX and CONFIG_AUDIO_QGKI configs
are enabled.
Change-Id: I31864e8b764dbcb40e0b96ac3a98f626dab315d2
Signed-off-by: Vignesh Kulothungan <vigneshk@codeaurora.org>
Update speaker playback sequence on wsa883x codec to
avoid click and pop and loss of VI sense data on speaker.
Change-Id: I8ec7072b63bef6c2e7bd64c96df4d98852c4f40d
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
Since clock stop mode is supported, disable mic bias supply
after a successful dmic probe.
Change-Id: I1a545969601367cc22844d1ab8467fb3722d882f
Signed-off-by: Vignesh Kulothungan <vigneshk@codeaurora.org>
Update sequence to enable temperature sensor in wsa883x to
read proper temperature measurement.
Change-Id: I7db16344a92b82539929511bd0de322ed086beb7
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
Because of a HW limitation in DSP, while switching
RCG from TX MCLK to VA MCLK for SVA use cases
a glitch is seen on AHB bus leading to data
corruption in registers.
So, while doing a mux switch for VA RCG clock selection,
do not configure the muxsel register in HLOS as it is
taken care in DSP itself as a workaround for HW limitation.
Change-Id: Iccbe714397796259fa55f9852ece387e949b12e8
Signed-off-by: Aditya Bavanari <abavanar@codeaurora.org>
Signed-off-by: Vignesh Kulothungan <vigneshk@codeaurora.org>
Remove sound wire dmic device from master device list only during
critical error and not for probe defer.
Signed-off-by: Vignesh Kulothungan <vigneshk@codeaurora.org>
Soundwire DMICs provide the same quality as regular DMICs but
the interface is soundwire. This reduces the number of pins
on the MSM. Enable soundwire DMICs on lahaina.
Change-Id: I4245369fdcb29cf96f315ebc1d2e9a83a0fbc14b
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
Add micbias control API to enable SWR DMICs on lahaina target.
Change-Id: I48152971e1af8dedc98ada20e4e808cf18720869
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
Some usecases need soundwire bus clock frequency to run at
lower clock rate for better power and performance. Update
soundwire bus clock frequency based on usecase.
Change-Id: I2e786d9f5d5d2ec3841daa934802eeafa79a8f6c
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
Update the codec dai name for slimbus_7 backend dailink used for BT use
cases.
Change-Id: I7330f95a106a7c5b3b9d8c588f93342d466d2d2c
Signed-off-by: Banajit Goswami <bgoswami@codeaurora.org>
POWER_SUPPLY_TYPEC_SINK_AUDIO_ADAPTER is not supported on new
kernel-5.4. Update mode to TYPEC_ACCESSORY_AUDIO for analog
type-c headset.
Change-Id: Id46ea2eebea8257a48134431f07a81b6ed7e6c7d
Signed-off-by: Meng Wang <mengw@codeaurora.org>
Disable clock gating when soundwire is out of clock stop mode.
Change-Id: I97187fa2deed26fb3270abee1d05f679ace2c0c4
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
