Add remote debugger device configuration. The Remote Debugger driver
allows a debugger running on a host PC to communicate with a remote
stub running on peripheral subsystems.
Change-Id: If059c713e4cc48eb32f9bfee8a5303c61854e022
It's expected that the EUD clock, GCC_USB_PHY_CFG_AHB2PHY_BCR,
is enabled by the bootloader and there's no reason for the
driver to explicitly cast a vote on it. Moreover, this clock
is binded with the reset framework's clock, GCC_GP1_CLK_SRC.
Hence, explicitly enabling GCC_USB_PHY_CFG_AHB2PHY_BCR would
also enable GCC_GP1_CLK_SRC and it would not be managed
properly. Hence, do not vote for GCC_USB_PHY_CFG_AHB2PHY_BCR
explicitly.
Change-Id: I673f1c9e0f08938cdf26add47194332d1c7058a5
Update the devfreq_icc documentation to add support for L3 BW
voting devices which require an additional bus width property to
be defined.
Change-Id: Iec16c5f666b2643971d45cb48c97015407372853
The PWM PPG feature in PM8350C uses two separate nvmems to store the
lookup table and the per-channel data. It also does not need a PBS
client for the PPG feature.
Change-Id: Iaf506cca458fb3c51b849d91383135ab62e9f829
Add HBoost register address base so that the haptics driver can
access the module to get the supported voltage range.
Change-Id: Ia19a05d15058121f5d23ba575ad27e8ea6d40e02
Add HBoost register base address so that supported voltage range for
haptics peripheral can be read.
Change-Id: I00bd50e8ceff44e2ad1fbd2691d93ee3c2cabf0d
Add an SPMI PMIC arbiter device so that it is possible to
communicate with PMICs attached to the SPMI bus.
Change-Id: I2f325f3b6774afcf2520ee1e8db07ff08ce4d4c2
IPA AP doesn't access IMEM. So there is no need to vote for imem
from AP driver. Make a change to remove the vote. Also fix the
CNOC vote in SVS2 configuration.
Change-Id: I2d6b98140db30504c198b500727242814d26d97e
The Remote Debugger driver allows a debugger running
on a host PC to communicate with a remotestub running
on peripheral subsystems.
This snapshot was taken as of msm-4.14 commit.
Change-Id: I7967c48542f77764af3e8623370e1450ab433903
PWMs on PM8350C require the nvmem devices SDAM21 and SDAM22 to store
pattern data as well as per-channel data. Add the required devices to
PMK8350 so that they may be referenced and used by the PWM node.
Change-Id: I762ff0c81ed7855d52231be81b8e08abfef5e708
Some targets such as PM8350C have a two-nvmem scheme in which LUT
pattern data is stored separately from the per-channel data. Update the
dt-bindings to reflect this.
Change-Id: I01c8e619c4bb758a3ea8436a689fa58059d10b0c
