Currently IRQ APIs are combined with notifications to VMs for sharing the
handles. This limit the clients for managing the error handling from the
drivers. Hence separate the notifications from the actual APIs so that
clients manage the error handling better. Add support for notifications
like IRQ_LEND/ACCEPT/RELEASE from SVM to PVM when SVM accept the irq
handle shared by PVM.
Change-Id: I49999c2d9494c68b1542680e521c012a25e3f6a8
Signed-off-by: Murali Nalajala <mnalajal@codeaurora.org>
For firmware and RDDM images, notify MHI driver not to free them after
successful allocation. This can help avoid future memory allocation
failure.
Change-Id: Ic19d42c6d56707200099969e36da91f4afed0163
Signed-off-by: Yue Ma <yuem@codeaurora.org>
This allows controller to keep the memory allocated for bhi
vector table for rddm and fbc images. Memory remains allocated
after controller powers down. Add a controller flag to make the
decision for memory allocation.
Change-Id: Ic8aee54ae57f5f9351158b18cd96faf7eeb81429
Signed-off-by: Hemant Kumar <hemantk@codeaurora.org>
Enable CONFIG_QCOM_INITIAL_LOGBUF for Holi. This enables
copying of dmesg logs into separate buffer at 100 sec from
bootup.
Change-Id: I36b7addc6060fc6cea03cc2cf006d454c9a1a6d6
Signed-off-by: Ashish Bhimanpalliwar <abhiman@codeaurora.org>
When ECM is enabled, disable ECM if display goes blank, and reenable
ECM once display restores to unblank. This helps in keeping ECM HW
enabled only when display is active.
Meanwhile, update the logic a little bit on calculating the average
current. When any of the accumulated values is invalid, just ignore
the calculation instead of disabling the ECM.
Change-Id: Ibfe973df4dabd1b1cd48927ce567a094da6382a3
Signed-off-by: Fenglin Wu <fenglinw@codeaurora.org>
Glink irq for all the remote edges are registered with same name
glink-native. It is difficult to distinguish each irq in logs.
Appending remote edge name to generic irq name.
Change-Id: I6ead87e0e4adae204535b599d07d9471387c861b
Signed-off-by: Deepak Kumar Singh <deesin@codeaurora.org>
Add support to use parent_map structure for mux clk parent.
Change-Id: I3f3655387bd8a7a3046a801ece921576d4e69e4b
Signed-off-by: Naveen Yadav <naveenky@codeaurora.org>
There could be instances where the RCG configuration update or readback
could fail. Notify the caller of the failure. Add support to change
scope of mux_div_get_src_div() in order to use it globally.
Change-Id: Ica07c28cede695785db81697effcb40ab6b717d4
Signed-off-by: Amit Nischal <anischal@codeaurora.org>
Signed-off-by: Taniya Das <tdas@codeaurora.org>
Signed-off-by: Naveen Yadav <naveenky@codeaurora.org>
